470 Complete Hull-complete with Rudderstock, all ropes & line & measurement certificate
Each boat is fitted with the following standard equipment:
- Carbon jib brackets
- Mackay mast puller
- North spinnaker bags
- Non-skid 3M Decktread on gunwale
- Four inspection ports in side tanks
- Forward inspection hatches with inspection port fitted in port side hatch
- Mylar transom flaps over 100mm X 25mm rounded holes
- Mylar centreboard gaskets
- Two Bailers mounted forward of traveller bulkhead
- Mackay Rudder stock with Carbon tiller extension
- Spare gel coat
Please configure your custom 470 and select your required accessories using the options below. All options are set to default to start with.
470 Complete Hull-complete with Rudderstock, Robline ropes & measurement certificate is fully configurable using the Fitout tab ...
Cleat on side of case; lines out to side decks with take-up
2:1 at base of mast then 6:1 along starboard side of centrecase with control lines exiting each side at the aft end of centrecase under mainsheet swivel and leading through Harken cleats (338) on carbon brackets to Harken blocks on side tanks immediately aft of traveller. Then line goes to 6:1 take-up system on port side of centrecase
NZD $360.00 ex GST
Separate up and down. 4:1 up & 2:1 down. Up has a 2:1 purchase from centreboard leading through exit box at front of centrecase to another 2:1 purchase under case on the starboard side. Line exits aft end of centrecase in front of traveller on starboard and extends to Harken block (224) on the side tank, Line then crosses the cockpit to another Harken block (224) and re-enters the centrecase to bungee take-up. Down leads through Harken cheek block (350), on top of the centrecase on the port side and extends to Harken block (224) on side tank. Line then crosses boat to another Harken block (224) and re-enters the centrecase to bungee take up.
